Viewer Colors and Composites
The Results, Registration and Training viewers share one Color panel. Use it to choose how each staining is displayed and to overlay several stainings as a composite.
Color settings change the display only. They never change image data, cell detection, classification or measurements.
Open the Color panel
Click the palette button at the top right of the viewer.
On desktop, you can drag the panel anywhere on the page. On phones and tablets, it opens as a sheet at the bottom of the screen.
Press Esc or click × to close it.
Show one staining or a composite
A single staining is shown in gray by default. You can connect it to another color.
To overlay several stainings, choose Composite:
- Results: choose Composite next to the staining names. It shows every staining imaged on the selected slice and is available when the selected staining has an image on that slice.
- Registration: choose Composite in the staining selector, or press
Dto cycle through the stainings and Composite. In4x reference + detailprojects, the reference image stays gray and the detail image shows the composite. - Training: choose Staining, Nuclei or Both. Both overlays the trained staining and its nuclei image, the two channels the classifier sees.
Dswitches between the staining and the nuclei image.
A new composite connects the first 4 stainings, each to its own staining color. Up to 8 stainings can be shown at once. To show another one, disconnect one first.
NeuroQP overlays stainings pixel for pixel from the top-left corner. It does not align stainings to each other. A staining whose image size differs from the displayed image by more than 2 pixels is grayed out in the panel.
Connect stainings to colors
The left column lists the stainings in the viewer. The right column lists the colors: each staining's own color, then Red, Green, Blue, Gray, Cyan, Magenta and Yellow.
- Drag a staining to a color, or click the staining and then the color.
- A staining can connect to several colors, and a color can receive several stainings. Overlapping colors add up.
- Click a color to change its shade or enter a hex value.
- Drag a connection to another color to move it. Drag a color's dot to move all of its connections. Drop a connection in empty space to remove it.
- Click the reset button to return to the default connections.
Adjust range and brightness
Click a connection to open the staining histogram.
- Drag the left and right cutoff lines to set the black point and white point. Values below the black point show as black, and values above the white point show at full color.
- Drag the plateau on the right up or down to change brightness.
- Use a preset to set the range from the histogram. 0–100 uses the sampled minimum and maximum. 0.1–99.9, 0.5–99.5 and 1–99 clip that percentage at each end.
- Switch the histogram between Linear and Log to see rare bright or dark values.
The histogram is computed from a low-resolution version of the image, so it is an approximation of the full-resolution values.
Edit several connections at once
Ctrl or Cmd click toggles a connection in the selection. Shift click adds one, and Ctrl+A selects all.
Range, brightness, presets and reset then apply to every selected connection. Presets use each staining's own histogram.
The trash button removes the selected connections.
Saved settings
NeuroQP saves your color settings per project and per viewer. Results, Registration and Training each keep their own settings, and they apply to every slice in that viewer.
Settings are personal. Other members of your organization keep their own.
Settings from the previous brightness controls are not carried over.
Using viewer images in figures
Two people can display the same image differently. When you use a viewer screenshot in a figure or presentation, record the black point, white point and color of each staining so others can reproduce it.
